Four-component thixotropyc epoxy-based mortar of high resistance and adherence

EPOAIS 4G

¡Compártelo o guárdalo!

EPOAIS 4G , FOUR-COMPONENT THIXOTROPYC EPOXY-BASED MORTAR OF HIGH RESISTANCE AND ADHERENCE

EPOAIS 4G

FOUR-COMPONENT THIXOTROPYC EPOXY-BASED MORTAR OF HIGH RESISTANCE AND ADHERENCE

Description Four-component thixotropyc epoxy-based mortar of high resistance and adherence, EPOAIS 4G ?

Four-component epoxy mortar, epoxy bondings, selected aggregates and special fibers with high mechanical resistance. Special for works where high resistances and high adherenceare required, mainly in floorings.

Aplication Four-component thixotropyc epoxy-based mortar of high resistance and adherence?

EPOAIS 4G is used for works that require high mechanical resistance mainly on floorings with heagy traffic or high traffic frequence. Reparation or reinforcement of expansion joints edges on industrial floorings both new building or repairing works.

Features and Benefits de EPOAIS 4G , Four-component thixotropyc epoxy-based mortar of high resistance and adherence

  •   HIGH MECHANICAL RESISTANCE
  •   HIGH ADHERENCE
  •   WITHOUT SHRINKAGE
  •   RESISTANT TO CHEMICAL PRODUCTS
 COMPRAR

¡Compártelo o guárdalo!

Surface preparation

The surface must be clean, firm and dyr. Mortar and concrete must be cured for over 28 days and without surface grouting. In the case of metals rust must be removed completely by mechanical means.

Modes of application Four-component thixotropyc epoxy-based mortar of high resistance and adherence?

  Homegenize A and B components separately. - Mix A and B components and when they are well homogenized add C component slowly and after D component. The admixture of A and B component must be done by low-revolution electric mixer. - More quantity that the mortar can be applied in 30 minutes at 20ª shouldn´be prepared. - The prepared mortar must be applied and compacted by a stainless steel trowel, spatula, etc… - In the case of fillings with high thickness is recommended to apply more than one layer. The thickness of each layer can be higher than 5 cm. In order to improve the adherence betwenn layers, thick, clean and dry sand must be sprinkled over the fist layer still wet and before applying the second one remove the loose sand.

Clean up

With epoxy solvent while the material is wet. Once it hardens only can be removed by mechanical means.

Performance Four-component thixotropyc epoxy-based mortar of high resistance and adherence

2 kg/sqm per mm of thickness

Storage Four-component thixotropyc epoxy-based mortar of high resistance and adherence

Two years in their original packages protected form the weather, stored in cool and dry places.

Documentation Four-component thixotropyc epoxy-based mortar of high resistance and adherence

Productos relacionadas

MÁXIMA CALIDAD.
En materias primas
y construcción.
FEDER INNTERCONECTA

2015-2017 SHIAC (ITC-20151250): DESARROLLO DE TECNOLOGÍAS DE HIGIENIZACIÓN PARA LA REDUCCIÓN DE RIESGOS BIOLÓGICOS EN ACUICULTURA
El proyecto SHIAC tiene como objetivo principal la investigación y desarrollo de una estrategia integral que permita reducir el riesgo biológico en acuicultura, integrando diferentes medidas tanto de tipo activo como pasivo para la prevención de patologías con una gran incidencia económica en el sector, y aportando soluciones más sostenibles ambientalmente a las actualmente empleadas en acuicultura.
Grupo Tres Mares S.A actúa como socio representante del consorcio empresarial que ejecuta este proyecto el cual ha sido aprobado y subvencionado por CDTI en el marco de la convocatoria FEDER INNTERCONECTA 2015.